27 |
Gimbal control knob
, twist the knob can
change pitch angle of gimbal.
The frequency method for RC and receiver
This product built-in 2.4GHz receiver, the frequency interface is located in the
aircraft cabin. When shipping from the factory, RC and receiver have already
completed the frequency, it can be used after connecting to the power. If you
need to change the RC, you can use it after re-frequency.
Frequency step
1. Under the situation of RC close, use the frequency line and then give the
aircraft power, the green light of the receiver flashes.
2. Put the RC throttle in to the lowest position, and then turn on the RC. After
successful connected, the green light of the receiver will put out.
3. Remove the frequency line, the green light of the receiver is lighting.
Before flying
1.
Install the transmitter batteries.
⑴
Open the battery compartment cover of the transmitter.
⑵
Install 4AA battery in accordance with the position and negative pole.
⑶
Close the battery compartment cover of the transmitter.
Note
：
①
Do not use the RC (receiver) with the third party remote control equipment.
②
Make sure the battery provides enough power, RC red light flashes and
has a sound “B-B-B……”alarm sound, change the new battery.
