32 |
ground. and use the stick to adjust the movement state of the aircraft.
(5) After reaching the desired position, pull the throttle in to the neutral position
（
keep the roll/pitch/yaw stick is in the neutral position
），
change the control
switch ,change the flight mode of aircraft .
4. Drop the aircraft slowly, after landing throttle receive the lowest, pull the
throttle and flight stick into the left corner for 5 seconds. lock the aircraft ,stop the
motor.
（
The throttle stick located in the lowest position after landing .wait for 5
seconds can start the motor
）
5. Disconnect the aircraft power, and then turn off the RC, complete the flight.
Note
：
①
After unlocking the aircraft, motor starts, if you find the green tail light still
flashes, it is indicate that stick pulls into the right bottom corner for a long
time, the aircraft starts to the automatic calibration balance state. do not
