- There are no water, gas or power lines inside the wall
- The wall to which the appliance is to be fixed must be made of masonry and/or heat-resistant, fire-
retardant and solid material (not wood or synthetic material), flat and free of irregularities; the ceiling
must also be made of fire-retardant and heat-resistant material.
- the appliance can be installed at least 2.0m from the ground (height referred to the lower edge of
the appliance), is positioned so that it cannot suffer impacts and that the air outlet grid has a free
space of at least 100cm, and at least 40cm at the sides.If installed in a bathroom, in addition to the
height from the ground, it must be ensured that the switches and control devices cannot be touched
or reached by a person in the bathtub or shower.
- the appliance is away from other sources of heat, flammable materials (curtains, upholstery, etc.),
flammable gases or explosive materials (spray cans) and materials that can be deformed by heat.
•
This appliance must not be used in any type of vehicle or restricted space (lifts, camper vans,
cars, cabins etc.).
•
To install the appliance, proceed as follows and refer to the figures:
- The appliance must be fixed in such a way that it is horizontal and the air outlet grid is on the
underside.
- the fixing is provided by means of 2 screws that engage in the 2 "lock hole" slots made on the rear
panel.
Drill 2 perfectly horizontal holes, with a distance of 39.8 cm and at least 215 cm from the floor (to
draw the holes use the template obtained in the lower flap of the package).Insert the expansion
dowel and drive in screws with head havinga 8mm diameter, suitable to fit in the slots (see figure
on the side)
•
Ensure that the power cord is correctly positioned and does not come into contact with hot parts
or sharp edges or become wound around the appliance itself and is not twisted.
•
In the event of a fault or malfunction, switch off the appliance and have it checked by a qualified
technician.
