3 or 4 uses. In very hard water areas we recommend the use of
Vinegar Solution
(75%water+25%vinegar) to clean the tank.
·
Do not refill the tank while it is still hot, allow it to cool down
for a few minutes before refilling.
·
The plug of the supply cord must be removed from the socket-outlet
before the water reservoir is filled with water.
·
Never empty the Steam Station when the water inside the generator
tank is still hot.
·
Do not place the appliance in water or in any other liquids.
·
Do not touch the appliance with wet hands or feet whilst the appliance
is connected do the mains.
·
Never leave the appliance unattended whilst it is connected to the
mains.
·
Do not allow the Steam Station to be used by children or by people
who are not familiar with the usage instructions.
·
We recommend that the appliance be disconnected from the mains
whenever it is not in use.
·
Do not leave the appliance exposed to wind or rain.
·
Do not lay the hot appliance on surfaces sensitive to heat.
·
Do not use electric extension leads that are not authorized by the
manufacture, as they may cause damage or fire.
·
Never direct the jet of steam towards small particles of debris
without firest protecting the user’s eyes.
·
The filling aperture must not be opened during use
·
The iron must be used and rested on a stable surface.
·
When placing the iron on its stand, ensure that the surface on which
the stand is placed is stable.
·
The iron is not to used if it has been dropped, if there are visible
signs of damage or if it is leaking.
_________IMPORTANT__________
Before leaving our factory all our products are rigorously
tested.
However, your steam station may contain some residual water in the
boiler or steam tube.
_____PREPARATION FOR USE_____
1a. Open the Cover of water tank (
6
) and fill the water tank with about
1 liter of water making sure that it does not overflow.
2a. Connect the power supply cable (
7
) into an earthed power supply
of the correct voltage.
3a. Switch on the steam station by pressing the switch (
10
), the
Indicator light of steam button (
5
) is on, make sure the steam
button is off and put the iron on the thermal isolated panel.
4a. Check the indicator light of
“
No water
”
(
8
) is on or off, open
Summary of Contents for Shuttle
Page 13: ......
