43 of 271
6. This is now a good time to clean, rethread, and Insert the bobbin and case into the machine with
the pigtail facing up. Push on the bobbin case until it snaps into place.
7. Trim the thread to 2-3 inches.
This completes the hook maintenance procedure.
Weekly Maintenance
WARNING!!
If you currently have a hoop or clamping system on the machine, please remove it.
Failure to fully remove a clamping system can result in damage to the machine.
Needle Drive
1. Color change to Needle 16.
2. Go to “Tools>Maintenance>Head Timing Tab”.
3. Go to “Top Center”
4.
Using a small oiler bottle, put twenty-five drops (25) of sewing machine oil in the oiling change as
shown in the image.
•
Note: You may have to add a few drops and wait before adding more to prevent the channel
from overflowing.
5. After adding the oil, wait ten minutes before continuing.
6. In the Head Timing Tab, go to “Head Up”.
Table of Contents
