3-20
Lamps
Operation Manual for the EMT 10T, 10/4, and 10/4T
Melco Embroidery Systems
Lamps
EMT 10T
The EMT 10 comes with a flexible lamp attached to
the table. The lamp has a separate ON/OFF switch
located on the bulb case (Figure 3-22). Push to turn
the lamp ON or OFF.
To change the bulb, turn the power off, then
unscrew the bulb case (refer to Figure 3-22). Use a
replacement bulb from Melco (one is provided in the
operator kit).
EMT 10/4 or 10/4T
The EMT 10/4 has built-in fluorescent lights above
the table. The lights have a separate ON/OFF switch
located next to the main power switch (see Figure 3-
23). Push to turn the lamp ON or OFF.
To change the bulb, turn the power off, twist the old
bulb slightly, then remove. Align the contacts on the
new bulb with the contacts on the machine. Insert
the new bulb and twist into place. Use a 3’ 25W flu-
orescent bulb (Melco part number 010394-01).
Figure 3-22
Figure 3-23
ON/OFF
switch
Light
switch
Power
switch
Summary of Contents for EMT 10/4
Page 52: ...2 28 Quick Start Operation Manual for the EMT 10T 10 4 and 10 4T Melco Embroidery Systems ...
Page 108: ...6 10 Error Messages Operation Manual for the EMT 10T 10 4 and 10 4T Melco Embroidery Systems ...
Page 126: ...INDEX Operation Manual for the EMT 10T 10 4 and 10 4T ...
Page 127: ...Quick Ref erence Guide for the EMT 10T 10 4 and 10 4T 11817 Revision A ...