Meler MV, Instruction Manual

MELER GLUING SOLUTIONS

1-2

SAFETY GUIDELINES

Mechanical components

The applicator equipment installation where the applicator is placed, uses 

moveable parts that may cause damage or injury. Use the equipment correctly, 

and do not remove the safety guards while the equipment is in operation; 

prevent the risk of possible entrapment due to moving mechanical parts.

Do not use the product if the safety devices are not in place or appear to be 

inadequately installed.

The manual applicator does not presents any risks in terms of mechanical 

movements.

Electrical components

The MV applicator operates with a one-phase current LN ~ 230V 50Hz + PE at 

a certain rated power. Be sure the the applicator connector is placed correctly 

on the hose electrical connector. 

Once the applicator is connected to the hose, it will be correctly grounded as 
well.

Hydraulic components

As this is a pressurized system, precautions related to this type of equipment 

must be observed.

Before each operation, always make sure that the adhesive circuit is 

completely free of pressure. There is a high risk of hot particle projection, 

along with the corresponding danger of burns.

Use caution with the residual pressure that may remain in the hoses when the 

adhesive cools. When reheated, there is a risk of hot particle projection if the 

outputs are left open. 

Thermal components

The MV applicator operates with temperatures reaching up to 200 °C (392 °F).  

Although the applicator has insulated covers, must be operated using 

adequate protection (clothing, footwear, gloves and protective glasses) that 

completely cover exposed parts of the body.

In case of burns, immediately cool the affected area with clean, cold water. 

Seek medical attention as soon as possible from the company’s medical 

service or the nearest hospital. Do not try to remove the adhesive material 

from the skin.

Noise

The noise level of the system is well below allowable levels, and therefore 

does not present a specific risk to be taken into consideration.