MAINTENANCE
6-1
MA-5096-E
MV APPLICATOR MANUAL
6. MAINTENANCE
Warning: Manual MV applicators are equipped with the latest technologies
with certain foreseeable risks. Therefore, only qualified personnel with
sufficient training and experience should be allowed to use, install or repair
these applicators.
The following section describes how to perform the various tasks on the
applicator, as required for proper maintenance.
Access to the interior of the applicator
MV applicators include three side plates to protect the user from possible
burns.
To remove the side plates, use an Allen wrench to remove the 3 screws that
hold them together.
The side plates are easy to remove once the 3 screws have been loosened.
If the MV applicator has a 90º pneumatic intake, this will have to be removed
to release the rear side plate of the applicator body. The intake can be
removed easily with a wrench.
Summary of Contents for MV
