MELER GLUING SOLUTIONS
6-2
MAINTENANCE
Replacing the body union fitting (pneumatic trigger)
The side plates have to be removed before replacing any sensors or heating
resistances.
1- Use an Allen wrench to remove the 4 screws that connect the two body
parts.
2- Remove the housing gasket in the pneumatic distributor body and assem-
ble all the parts again.
Replacing the pneumatic trigger of the applicator
1- Remove the 2 screws that join the grip to the applicator body.
2- Push the grip to separate it from the body. This step should be performed
carefully so the pneumatic tube gaskets are not lost during extraction.
Pneumatic tube gaskets
Summary of Contents for MV
