NB: THE LIGHT INDICATOR STOPS FLASHING
The remote control exits programming mode and the light indicator stops flashing:
• if no keys are pressed for 14 seconds
• if an invalid brand code is entered
• if a key other than
ON/OFF
or
PLAY
is accidentally pressed
• if the end of the code search list has been reached. In this case, consult the website
www.meliconi.com/guide
GLOBAL SEARCH REMOTE CONTROL PROGRAMMING
The quickest and easiest way to programme the remote control is by consulting enclosed
CD or the website
www.meliconi.com/guide
.
Warning:
programme one appliance at a time!
1
. Turn on the appliance to be programmed:
- if a
VCR
, insert a cassette
- if a
TV, SAT
or
TER
select a programme
- if a
DVD
insert a DVD.
2
. Hold down the selection key for the appliance to be
programmed for 5 seconds.
3
. When the key is released, it will start to flash. Enter the
code
0000
; the selection key flashes more quickly to
indicate that the remote control is ready for the search.
4
. Point the remote control at the appliance. Press and slowly
release the
ON/OFF
key or
PLAY
for the
VCR
and
DVD
several times,
stopping
when the appliance responds
correctly to the command.
5
. When the appliance responds correctly, press
OK
to
confirm. Three flashes indicate that the search operation
has been completed correctly.
ADDITIONAL CHECK
Check that some of the other keys, corresponding to those on your original remote control, work correctly.
If the commands function incorrectly or erratically, you have probably entered a code for a similar remote
control but not the right one. In this case, repeat the search procedure starting from
point 2
.
To display and make a note of the code memorized by means of the search,
follow the instructions described in the paragraph CURRENT CODE DISPLAY.
NB: THE LIGHT INDICATOR STOPS FLASHING.
The remote control exits programming mode and the light indicator stops flashing:
• if no keys are pressed for 14 seconds
• if a key other than
ON/OFF
or
PLAY
is accidentally pressed
• if the code search list is completed. In this case consult the enclosed CD or the site
www.meliconi.com/guide
This operation can take up to 20 minutes and should be carried out if you have not succeeded
in programming the remote control by means of the method described above.
or
+
+
+
8
5 SEC.
or
or
VCR
TER
