1
. Press the select key for which you want to know the code
and hold down for 5 seconds.
2
. When the key is released it will start to flash; press and
release the
1-/--
key
within 8 seconds
.
3.
After a pause of several seconds, the indicator light produces
four series of flashes with a space between them, corres-
ponding to the code you are looking for. Count the number
of flashes; each series of flashes corresponds to one figure
in the code.
10 flashes correspond to 0
.
4.
Note the code on the adhesive label inside the battery cover
in case you have to reprogramme the remote control subse-
quently.
C U R R E N T C O D E D I S P L AY
NB: this operation cannot be interrupted and the remote control
cannot therefore be used until the end of the four series of flashes.
To find out the code of your remote control, follow this procedure:
Although not indicated on the keypad,
some keys can be used for additional commands.
Find them on your remote control by pressing the keys one by one and discovering the commands that
interest you.
In particular, the additional functions most frequently used, such as
NORMALIZATION
,
COLOUR
and
BRIGHTNESS
, can be found on the following keys:
TV FUNCTIONS ALWAYS ACTIVE
HOW TO USE THE ADDITIONAL COMMANDS WHICH DO NOT APPEAR ON THE KEYPAD
For the functions used less frequently, look for the additional commands on the site
www.meliconi.com/guide
. As well as easily finding the code to programme your remote control, consulting
the
on-line guide
will help you to find which keys on the remote control correspond to the additional
commands. You can memorise the additional commands on the
F1 - F2 - F3 - F4
function keys.
Normalization:
Brightness (+):
or
Brightness (-):
or
Colour (+):
or
Colour (-):
or
If you know the exact code with which to programme the remote control, enter it as follows:
ENTERING THE CODE
1
. Hold down the selection key for the appliance to be
programmed for 5 seconds.
2
. When the key is released it will start to flash; enter the
code (
e.g. TV 1100).
Three flashes
indicate that the
operation has been completed correctly.
The functions
Mute
,
Vol -
,
Vol +
and
AV
are memorized on the keys
F1
,
F2
,
F3
,
F4
. These functions
can be used to control appliances other than the TV. For further information consult the enclosed CD or
the on-line guide on the site
www.meliconi.com/guide
......................................................... =
1
.............................................. =
3
=
0
............................ =
6
Code obtained =
1 3 0 6
9
5 SEC.
or
or
VCR
TER
5 SEC.
or
or
VCR
TER
+
+
+
1
1
1
