You can also use the TV - VCR - SAT - DVD selection keys for different appliances.
See the table below.
communicates the code by flashing
the three numbers separately. Count
the number of flashes for each code
number. For example, for the code
306, the button flashes three, zero and
six times to give:
= 3
= 0
= 6
5
. Note this code on the label inside the
battery cover for rapid consultation.
NOTING THE PROGRAMMED CODE
To find the code for your remote control:
1
. Press one of the TV - VCR - SAT - DVD
selection keys for the appliance whose
code you want to identify.
2
. Hold down the SHIFT and ON/OFF
keys together until the TV - VCR -
SAT - DVD selection key starts to
flash.
3
. Release the SHIFT and ON/OFF keys
and then press and release the 1-/--
key.
4
. After a few seconds, the TV - VCR -
SAT - DVD selection key you used
USING THE ADDITIONAL COMMANDS WHICH DO NOT
APPEAR ON THE KEYPAD
Although not indicated on the keypad, some keys can be used for additional commands.
1
. Use your
CONTROL 4 Plus
remote control to find them by pressing the following keys one by
one:
2
. The most frequently used additional commands like MENU SCROLL – COLOUR –
BRIGHTNESS and NORMALISATION are located as follows:
normalisation
menu (up)
menu (up)
+
brightness (-)
red
brightness (-)
+
red
menu (down)
menu (down)
+
brightness (+)
green
brightness (+)
+
green
menu (right)
menu (right)
+
color (-)
yellow
color (-)
+
yellow
menu (left)
menu (left)
+
color (+)
blue
color (+)
+
blue
USING THE REMOTE CONTROL WITH MORE THAN ONE
APPLIANCE OF THE SAME TYPE
VOLUME CONTROL AVAILABLE AT ALL TIMES
If you have programmed the
CONTROL 4 Plus
remote control for the TV using
the TV selection key and for the VCR using the VCR selection key,
you can raise or lower the TV volume or use the mute function while watching
the VCR without having to press the TV selection key.
OK
1-/--
TV
DVD
SAT
VCR
TV
VCR
SAT
DVD
BUTTONS
APPLIANCES
TV
VCR
SAT
DVD
√
√
√
√
√
√
√
√
√
√
√
√
√
√
√
In this way, you can obtain all the
combinations required. Simply program
the remote control as follows:
Always write down the 3-digit code for your remote control on the label inside the
battery cover after running the search and saving the code.
This may be useful if you need to reprogram your remote control in the event of
accidental cancellation or when you change used batteries.
If you forget to write down the code or use the remote control programming
procedures
A
or
C
... don’t worry!
1
. One at a time, search for the codes
for each appliance, following any
of the programming procedures
A
,
B
or
C
described above.
2
. Make a note of the various
appliance codes.
3
. Enter the codes following the
programming procedure
B
from point 3
and assign the
appliances to the selection
keys as you like.
1-/--
2-
MENU
OK
AV
P
+
P
-
-
P
+
P
-
-
-
