If certain buttons do not work correctly, you are probably using an incorrect code destined for a very similar device; at this
point ignore
the
SMS
list and consult the
SETTING VIA MANUAL SEARCH
chapter to find a more suitable code.
(only to be performed if the
specific code
could not be found)
CAUTION
: the search procedure could take several minutes.
A)
Look in the table at the beginning of the booklet, referring to the column relating to the type,
the brand of device which you wish to control, and note the corresponding number in the
BUTTON column. If the brand is not present using zero
“0”.
(example: TV SONY = 3)
B)
Stand in front of the device to be controlled and make sure it is ON (not in stand-by).
If necessary, switch it on using the original remote control (if this is still working) or the
buttons present on the device itself. (on TVs they can be on the side or the top).
C)
Press and hold on the MELICONI remote control for at least 6 seconds one of the selection
buttons corresponding to the device you wish to control.
(example:
[
TV
]
)
D)
When the indicator light flashes, release and immediately press the numeric button identified in
the table for a moment.
EXAMPLE: 3
E)
Pointing the remote control towards the device to be controlled, press and hold on the
MELICONI remote control the
ON/OFF
[
button.
CAUTION:
you may have to keep the button pressed for a few minutes before the device
switches off.
F)
When the device switches off, IMMEDIATELY RELEASE the button and press the
[
OK
]
button.
G)
Three final flashes indicate that the operation has been completed successfully.
NOTE:
During the search the indicator stops flashing and the remote control exits the search mode in the following
cases:
• if for 30 seconds the indicated button is not pressed or if another button is pressed.
• if the list of codes to find is terminated. In this case consult the
website or contact the
customer service.
ADDITIONAL CHECK
Check that the MELICONI remote control operates your device also with the other main functions; if it does not,
REPEAT
the procedure from step
B
using the same brand number.
If, after various attempts, do not get a satisfactory result REPEAT the procedure from step B, using 0 (zero) as brand
number.
SETTING VIA MANUAL SEARCH
NOTE:
If you don’t receive an SMS on your mobile phone or if the message says
ERROR
or
NO CODE
, it means the
system has not been able to process the data you have sent.
Do not send another SMS
, only use the
SETTING VIA
MANUAL SEARCH
procedure or contact the customer service.
