24
UK
MAIN COMPONENTS
1.
Measuring cup
2.
Blender jug lid
3.
Blender jug
4.
Sealing
5.
Blade unit
6.
Jar holder cover
7.
Motor unit
PREPARATION
• Place the motor section (7) on a flat
surface and make sure it is standing
firmly. The suction cups under the
motor section will attach firmly to a
smooth surface.
• Attach the sealing (4) to the base of
the blender jug (3) and make sure it is
lying completely flat against the edge
of the blender jug. Attach the blade
unit, so the blade goes up into the
base of the blender jug, and screw
the blade unit firmly into place with
the jar holder cover (6).
• Fit the blender jug assembly to the
drive shaft of the motor section, and
turn it slightly clockwise, until it locks
into place and the safety switch en-
gages.
• Place the lid (2) on the blender jug.
• Place the measuring cup (1) in the
hole in the lid (2) and turn it clockwise
to lock it in place.
