29
UK
PREPARATION
• Wipe the evaporator (10), ice bucket
(13), ice shovel (12) and water tank
(2) with a well-wrung cloth before use.
USE
• Open the lid (5) and fill the water tank
(2) with water. The water level must
not reach the bottom of the ice bucket
(13). Close the lid again.
• Switch on the appliance using the
on/off button on the control panel (8).
The ICE indicator comes on and the
appliance begins to cool.
• The water in the tray (9) freezes to ice
cubes around the teeth in the evapo-
rator (10) and is fed by the conveyor
(11) over into the ice bucket once they
are ready. The first 3 times ice cubes
may be smaller or vary in size. This is
completely normal.
• If the ADD WATER indicator comes
on, a signal will be heard. Refill with
water and restart the appliance by
pressing the on/off button.
• If the ICE FULL indicator comes on,
a signal will be heard. Empty the ice
bucket immediately. Do not overfill
the ice bucket! If necessary, place the
ice cubes in the freezer if you don’t
intend to use them immediately.
• Switch the appliance off using the
on/off button when you have finished
using it.
• Pull the front of the appliance over
the table edge and hold a bowl under
the appliance. Take the silicone plug
(1) out of the water tank and allow the
rest of the water to run into the bowl.
Replace the silicone plug once the
water tank is completely empty.
CLEANING
• Unless clearly specified in the clean-
ing instructions below, please note
that none of the parts of this appli-
ance are dishwasher safe.
• Always clean the appliance immedi-
ately after use.
• Always switch the appliance off at the
wall socket and unplug before clean-
ing.
• Clean the inside and outside of the
appliance with a well-wrung cloth and
a little vinegar, if the water is hard. Do
not submerge the appliance in water,
and do not let water enter the appli-
ance.
• Ensure the appliance is clean and dry
before storage.
• Do not use chemicals. Never use
abrasive detergents or solvents.
