Installation and Basic Operation
Rev 1.4
Mellanox Technologies
36
To insert a FAN Unit:
1.
Make sure the mating connector of the new unit is free of any dirt and/or obstacles.
2.
Insert the fan unit by sliding it into the opening until slight resistance is felt. Continue press-
ing the fan unit until it seats completely.
Make sure that the new fan unit has the correct air flow direction. This can be verified
by checking the label on the fan unit and comparing it to the air flow label on the PSU.
The green fan status indicator should light. If not, extract the fan unit and reinsert it.
After two unsuccessful attempts to install the fan unit, power off the gateway before
attempting any system debug.