Rev 1.4
Mellanox Technologies
54
15. Interconnexion des unites INTERCONNECTION OF UNITS
16. Exposition au rayonnement grave
17. S’assurer que les enceintes sont appropriées
18. Cordons électriques CA homologués UL
Les câbles de branchement à l’unité RS232 et les interfaces Ethernet doivent être certi-
fiés UL de type DP-1 ou DP-2. (Note - lorsqu’il existe dans un circuit non LPS)
Protection contre la surintensité : Un appareil de protection répertorié facilement
accessible contre la surintensité du circuit de branchement et calibré à 20A doit être
incorporé dans le câblage électrique du bâtiment.
Mise en garde – l'utilisation de commandes ou de réglages ou l'exécution de procé-
dures autres que ce qui est spécifié dans les présentes peut engendrer une exposition au
rayonnement grave.
PRODUIT LASER DE CLASSE 1 » et références aux normes laser les plus récentes
CEI 60 825-1:1993 + A1:1997 + A2:2001 et NE 60825-1:1994+A1:1996+ A2:2001
Des enceintes électriques, mécaniques et incendie adaptées doivent être fournies par le
fabricant du produit final ou par l’utilisateur final.
Pour les prises électriques en Amérique du Nord, choisissez un cordon électrique
homologué UL et certifié CSA
à 3 conducteurs, [18 AWG], terminé par une fiche moulée, d’une tension nominale de
125 V, [15 A], avec une longueur minimale de 1,5 m [6 pieds] et d’une longueur maxi-
male de 4,5 m [18 pieds]
Pour les prises électriques en Europe, choisissez un cordon électrique harmonisé inter-
nationalement et marqué "<HAR>",
à 3 conducteurs, d’un diamètre de fil minimum de 0,75 mm2, d’une tension nominale
de 300 V, avec une gaine isolée en PVC. Le cordon doit avoir une fiche moulée d’une
tension nominale de 250 V et d’une intensité nominale de 10 A.