Hardware Installation
Rev 1.8
19
Mellanox Technologies
3.6
Cables and Modules
To obtain the list of supported cables for your adapter, please refer to
http://www.mellanox.com/
products/interconnect/cables-configurator.php
.
3.6.1 Cable Installation
1. All cables can be inserted or removed with the unit powered on.
2. To insert a cable, press the connector into the port receptacle until the connector is firmly
seated.
a. Support the weight of the cable before connecting the cable to the adapter card. Do this by using a cable
holder or tying the cable to the rack.
b. Determine the correct orientation of the connector to the card before inserting the connector. Do not try and
insert the connector upside down. This may damage the adapter card.
c. Insert the connector into the adapter card. Be careful to insert the connector straight into the cage. Do not
apply any torque, up or down, to the connector cage in the adapter card.
d. Make sure that the connector locks in place.
3. After inserting a cable into a port, the Amber LED indicator will light when the physical con-
nection is established (that is, when the unit is powered on and a cable is plugged into the port
with the other end of the connector plugged into a functioning port). See
nox Innova IPsec EN LEDs,” on page 50
4. After plugging in a cable, lock the connector using the latching mechanism particular to the
cable vendor. When a logical connection is made, the Green LED will light. When data is
being transferred the Green LED will blink. See
Section 9.3, “Mellanox Innova IPsec EN
.
Do not use excessive force when seating the card, as this may damage the system or the
adapter.
When installing cables make sure that the latches engage.
Always install and remove cables by pushing or pulling the cable and connector in a
straight line with the card.
