Mechanical Installation
Rev 1.0
29
Mellanox Technologies
The power supply can be replaced in case it fails. To replace the power supply, follow these
steps:
1. If a filler panel is installed, remove the filler panel.
Figure 22: Remove the PSU
2. If a power supply is installed, grab the handle with your thumb pointing toward the latch.
Push the latch with your thumb towards the handle while you pull the power supply out of the
appliance.
Figure 23: Insert the PSU
3. Insert the power supply module into the power supply cage and push all the way until it clicks
into place.
Do not run the appliance with openings due to missing parts. This may cause overheating
due to improper air flow.
