Steam Ironing:
- Fill up the iron as described in the section “How to fill the water deposit”.
- Plug in the iron.
- Steam ironing is only possible if you select the highest temperature***. Otherwise water may seep
through the base of the iron.
- Wait for the pilot light to go off. Turn the steam regulator to the desired position
- During pauses and when the ironing is complete, leave the iron standing upright.
- Unplug the iron by pulling the plug out of the socket. Pour out any leftover water and let the iron cool
down.
Spray:
- The spray can be used when dry ironing or when steam ironing.
- To do so, press the spray button. The spray button has to be pressed repeatedly to release the first
spray.
Steam blast:
Steam blasts gives an extra steam jet to help remove tough creases.
- Select the maximum temperature*** on the temperature gauge. Wait for the pilot light to go off.
- Press the steam blast button Wait a few seconds for the steam to penetrate into the fabric before
pressing again. For optimum steam quality, do not apply more than three successive blasts. The spray
button has to be pressed repeatedly to release the first spray.
Cleaning
- Unplug the appliance before proceeding to clean.
- Do not use solvents or abrasive products for cleaning.A damp cloth with a few drops of washing up liquid
is enough.
“Self-cleaning”
- It is important to self-clean the appliance at least once a month to remove calcium and any other built-up
minerals inside the iron.
- Fill up the deposit to the top.
- Stand the iron upright and press the plug it in.
- Turn the temperature gauge to the *** position.
-Lets the iron heat up until the pilot light turns off and back on again.
- Unplug the iron and place it over the sink.
- Put it into the self-cleaning position.
- Let the water flow out through the steam vents in the base whilst lightly shaking the iron.
- Release the self-cleaning button after a moment or when the deposit has been emptied and place the
iron in an upright position.
- Let the iron cool and then clean it.
Maintenance
- Any stains that may form on the base of the iron can be cleaned off using a cloth dampened with water
and white vinegar.
Problems and Solutions
- In the event of malfunctions, take the appliance to an authorized Technical Support Service.
- Do not try to dismantle or repair it yourself as this may be dangerous.
- If the mains connection is to be replaced, proceed as in the event of a malfunction.
This appliance complies with Low Voltage Directive 73/23/ EC and with Electromagnetic Compatibility
Directive 89/336 EC.
