3
SAFETY INFORMATION
Please read and understand this entire manual before attempting to assemble,
operate or install the product. If you have any questions regarding the product, please
call customer service at: 1-855-CHANT-US (1-855-242-6887) from 8:00 am to 5:00 pm
Eastern time, Monday to Friday.
1. The installation must conform with local codes or, in the absence of local codes, with the
National Fuel Gas Code, ANSI Z223.1 /NFPA 54, Natural Gas and Propane Installation
Code, CSA B149.1, or Propane Storage and Handling Code, B149.2.
2. Minimum clearance to the combustible materials is 3.61 ft(1100mm).
3. Perform a leak test with a soapy solution:
(a) To check gas connections.
(b) After connecting a new cylinder.
(c) Upon re-assembly after disassembly.
Please refer to the leak test procedure indicated in this instruction manual on page 12.
Replace the hose assembly prior to the appliance being put into operation if there is
evidence of excessive abrasion or wear, or if the hose is damaged.
The pressure
regulator and hose assembly supplied with the appliance must be used .The
replacement hose assembly/ regulator shall be that specified by the manufacturer.
4. If you don’t feel the heater is on a stable surface, use a ground screw to fix the base of
the heater on the surface where the heater is installed. Fix the base on an incline no
wider than 15 degrees.
5. Place the propane hose with regulator assembly out of pathways where people may trip
over it or in areas where the hose will not be subjected to accidental damage.
6. Materials or items when stored under the heater will be subjected to intense heat and
could be seriously damaged.
7. Clothing or other flammable materials should not be hung on the heater, or placed on,
under or near the heater .
8. Children and adults should be alerted to the hazards of high surface temperatures and
should stay away to avoid burns or clothing ignition.
9. Young children should be carefully supervised when they are in the area of the heater .
10. Any guard or other protective device removed for servicing the heater must be replaced
prior to operating the heater.
11. Installation and repair should be done by qualified service person, the heater should be
inspected before use and at least annual by a qualified service person.
12. More frequent cleaning may be required as necessary. It is imperative that the control
compartment, burners and circulating air passageways of the heater to kept clean.
13. Keep the appliance area clear and free from combustible materials, gasoline and other
flammable vapors and liquids.
14. Do not obstruct the flow of combustion and ventilation air.
