4.3 Module InsTallaTIon usIng CenTer MounTIng BraCkeTs
•
Modules may also be mounted using center clamps as shown in Appendix 8.2, for use with trackers.
•
Module clamps for center mounting must be based on MEMC approved extrusion and hardware.
•
For module loads higher than 2400 Pa, module clamps and hardware must be pre-approved by MEMC.
4.4 MeChanICal InsTallaTIon warnIngs
•
Installation and maintenance should be performed by qualified personnel only.
•
Use insulated tools during installation, troubleshooting and maintenance of photovoltaic modules.
•
Installers should adhere to all applicable local, regional, and national codes and regulations when designing and constructing
the photovoltaic system.
•
Do not stand or walk on any surface of the modules. Do not place any objects or load on the surface of the modules.
•
Precaution should be taken to avoid damage to the glass surface with or without anti-reflective coating due to improper
handling during installation.
•
Mechanical structures should not contact the module backsheet under any expected load conditions.
•
Additional mounting holes may not be drilled in the frame, glass or backsheet.
•
Ensure that frame weep holes (see Appendix 8.1) are not obstructed by the mechanical installation.
Installation Manual: MeMC silvantis 72 cell Pv modules
6 of 13
