NOTE FOR THE REPLACING OF MEMORY IC
If a service repair is undertaken where it has been required to change the MEMORY IC, the following steps should be taken to
ensure correct data settings while making reference to TABLE 1.
NOTE: Initial Data setting will not be possible if clock has been set. To reset clock, either unplug AC cord and allow
at least 5 seconds before Power On.
3.
4.
5.
6.
7.
8.
The unit will now have the correct DATA for the new MEMORY IC.
ADDRESS
DATA
83
ADDRESS
DATA
ADDRESS
DATA
ADDRESS
DATA
ADDRESS
DATA
ADDRESS
DATA
01
00
02
03
04
06
08
1B
C0
63
34
08
09
0A
0B
07
89
75
3B
00
10
97
14
00
15
16
17
18
19
1B
00
00
05
05
00
0F
1C
1D
1E
1F
20
22
04
39
8D
00
00
00
23
24
25
26
27
29
00
00
00
00
00
1.
2.
Fig. 1
ADDRESS is now selected and should "blink". Using the SET + or - keys on the remote, step through the ADDRESS until
required ADDRESS to be changed is reached.
Press ENTER to select DATA. When DATA is selected, it will "blink".
Again, step through the DATA using SET + or - until required DATA value has been selected.
Pressing ENTER will take you back to ADDRESS for further selection if necessary.
Repeat steps 3 to 6 until all data has been checked.
When satisfied correct DATA has been entered, turn POWER off (return to STANDBY MODE) to finish DATA input.
Enter DATA SET mode by setting VOLUME to minimum.
While holding down VOLUME button on front cabinet, press key 6 on remote control simultaneously.
ADDRESS and DATA should appear as FIG 1.
INIT 00 83
0010
0003
POWER ON
PLAY/REC
ADDRESS
DATA
Table 1
00
10
8C
0F
00
00
11
12
68
5C
05
14
0C
19
13
53
1A
A9
21
00
28
01
0D
0E
C4-1
