NOTE FOR THE REPLACING OF MEMORY IC
If a service repair is undertaken where it has been required to change the MEMORY IC, the following steps should be taken to
ensure correct data settings while making reference to TABLE 1.
NOTE:
•
•
Initial Data setting will not be possible if clock has been set. To reset clock, either unplug AC cord and allow at least
1 hour before Power On or alternatively, discharge backup capacitor.
No need the setting for after INI 6.
INIT 01 EB
ADDRESS DATA
Fig. 1
DATA
ADDRESS
0C
09
2B
16
56
INI
06
INI
05
INI
04
INI
03
INI
02
INI
01
30
Table 1
1.
2.
3.
Enter DATA SET mode by setting VOLUME to minimum.
While holding down VOLUME button on front cabinet, press key 6 on remote control simultaneously.
ADDRESS and DATA should appear as FIG 1.
4.
5.
6.
7.
8.
9.
The unit will now have the correct DATA for the new MEMORY IC.
ADDRESS is now selected and should "blink". Using the SET + or - keys on the remote, step through the ADDRESS until
required ADDRESS to be changed is reached.
Press ENTER to select DATA. When DATA is selected, it will "blink".
Again, step through the DATA using SET + or - until required DATA value has been selected.
Pressing ENTER will take you back to ADDRESS for further selection if necessary.
Repeat steps 4 to 7 until all data has been checked.
When satisfied correct DATA has been entered, turn POWER off (return to STANDBY MODE) to finish DATA input.
C3-1
