Quick Installation Guide for the Memorex RF ScrollPro Optical Mouse:
Hardware Installation
1. Open the battery compartment on the mouse and set the channel switch to either
“1” or “2”
2. Insert the 2AAA batteries into the battery compartment and close the cover.
•
If the Red LED display light is on, the mouse batteries have power; otherwise
plug the AC adapter into an appropriate power source and plug the connector
into the port located on the charging station. After you’ve completed this
step, slide the mouse into the charging station to charge the batteries. While
the mouse is charging the scroll wheel will illuminate.
•
To completely charge the batteries allow the mouse to remain in the charging
station for a minimum of 6-8 hours. *Note the initial charge will take
approximately 24 hours. When fully charged the batteries will last for
approximately 6-8 hours.
3. Set Receiver channel switch (located on the bottom of the receiver) to the same
channel selected in step 1. The default for both is channel 1.
4. Connect the Receiver to your computers mouse port (either via the PS/2 connector
and your available PS/2 mouse port or by applying the PS/2 to USB adapter and
plugging it into your computers USB port). The LED illuminator should light.
5. Press ID Link Button (which is located on the receiver bottom), the LED light
should begin to flash slowly at this time.
6. Press ID Link Button of the Mouse, the LED light blinking should begin to flash
rapidly.
7. Once the frequency is set, the LED light on the receiver will remain steadily lit.
However when the mouse is in motion the LED will flash rapidly.
Note
1. When there is low/no power in mouse, the scrolling wheel will illuminate. Charge
the mouse immediately.
2. While charging the mouse, the Receiver LED light will blink quickly. After
Summary of Contents for RF Optical Mouse
Page 1: ...RF Optical Mouse...
