5
Grill Installation and Operation
Installation Requirement
A dedicated GFCI protected electrical circuit is required for all Memphis Wood Fire Grills and controller systems. This
circuit should be installed by a Certified Electrician. Although the Memphis Grill only uses about 2 amps of current
during startup, any other equipment (refrigerator, pool pump, fountains, ect.) that have high current draw, consistently
or intermittently, from the same electrical circuit can cause potential issues and/ or interruptions with the performance
of the grill. We recommend an on/off switch to be installed in this circuit so that the grill can be easily disconnected
from power when not in operation. This will prevent the buildup of interference that could affect the controller’s
operation.
Hopper Lid Orientation
For easier pellet refill, the hopper lid can be
oriented to open toward the front of the grill instead
of the rear when access to the back of the grill is
difficult or unavailable. To switch the orientation to
be opened from the front, the shoulder bolts
holding the hopper lid must be removed. Rotate the
lid so the mounting holes are towards the back of
the grill. Re-insert shoulder bolts into the rivnuts
towards the back of the grill.
*Note: The fill shield must be flipped up to cover
the smoke vent in this orientation. This is used to
block pellets from falling into the grill via the smoke
vent.
Other Grill Information
Main Grate Area– 37.1 in X 17.4 in.
[94.3 cm X 44cm]
644 in. sq.
[4,149 cm sq.]
Top Grate Area– 37.1 in. X 5.5 in
[94.3 cm X 14 cm]
204 in. sq.
[1,320 cm sq.]
Optional Middle Grate Kit Area– 37.1 in. X 11 in [94.3 cm X 28 cm]
408 in. sq.
[2,640 cm sq.]
Grill Height with Hood Open– 47.1 in. [120 cm]
