7
Installation Step 3: Brackets
7. Remove the ash/grease drawers from the unit.
8. Fasten the left and right support brackets (items 13
and 14) to the unit using the ten 1/4”-20 stainless steel
hex bolts (item 5).
9. Fasten the rear support bracket (item 15) to the left
and right support brackets (items 13 and 14) with two
#10-24 x 1/2” long stainless steel screws (item 7).
10. This step is only to be done if the grill is going to be
supported by the four leveling feet (item 10) and not
the support brackets. Thread the four leveling feet
(item 10) into the bottom of the unit.
Follow the assembly steps listed below, prior to installation of the unit. The Unit can be supported by either the
support brackets (items 13, 14, and 15) or by the four leveling feet (item 10). Refer to page 4 for item part numbers,
descriptions, and quantities.
Note that the support brackets must be installed for either support method.
7-10
11. To reduce the clearance to
combustible materials, the
optional heat shield kit should
be used. Refer to page two to
determine if the heat shield kit
is required for your installation.
Follow the assembly
instructions provided with the
heat shield kit to properly
fasten the kit to the unit.
11
Optional:
