85-03-01058-O
FV33i Gen 3
Page
52
4.5
BENDING UP THE SHIPPING CLIPS
Once the unit is detached from the pallet by removing the securing lag screws that hold these shipping clips to the pallet, either
bend these clips up 90-degrees or break them off using a screwdriver and back and forth cold working motion (see below). A
bending relief is provided within the clip to ease bending or breaking. Bending the shipping clips up or removing them will be
necessary for Insert units which are to be installed in narrow width or shallow depth openings.
To bend the clips up or to break them off, follow these procedures:
1.
Insert the tip of a flat screwdriver (longer screwdriver is better) under the clip.
2.
Lift screwdrivers handle upwards and bend the clip up about 45-degrees.
3.
Remove screwdriver. Insert screwdriver tip into one hole in clip. Lift screwdriver up. To break clip off, repeat up down
motion of screwdriver seven to eight times.
Shipping Clip
STEP 1 & STEP 2
Bend Up Clip 1
STEP 3
Bend Up Clip 2