85-03-01058-O
FV33i Gen 3
Page
58
6.
Locate Pilot Light on left side of firebox between the two air shutter boxes.
While holding the pilot base body with large
vice grips tightly
loosen pilot light hood using a 7/16” open end wrench on the hex shape base. Rotate counterclockwise
¼ turn to loosen. DO NOT REMOVE THE PILOT HOOD, ONLY LOOSEN.
7.
Pilot arrives from the factory set for NG. Push NG/LP. Adjust clip inward all the way to set it for LP. See detail view,
below. If you see “NAT” printing on the adjustment clip, this indicates that the pilot is set to burn NG. push clip in so that
“NAT” is not visible.
8.
Hold pilot base tightly with vice grips
and tighten down hex shaped base of pilot using a 7/16” open end wrench.
Pilot Body
Figure 3-2 Pilot Orifice
Selection
9.
. Rotate counterclockwise ¼ turn to loosen. DO NOT REMOVE THE PILOT HOOD, ONLY LOOSEN.
10.
Pilot arrives from the factory set for NG. Push NG/LP adjustment clip inward all the way to set it for LP. If you see “NAT”
printing on the adjustment clip, this indicates that the pilot is set to burn NG. Push clip in so that “NAT” is not visible.
11.
Tighten down hex shaped base of pilot using a 7/16” open end wrench.
CAUTION: Always use two pinch tools to hold, loosen and tighten pilot hood base to prevent damage to pilot
mount bracket.
Pinch Pilot Base with Vice Grips
Main Gas Valve