85-03-01058-O
FV33i Gen 3
Page
20
Convection Blower System
Dual blowers are provided as standard equipment with this FV-44i Insert. The
dual blowers have an air output rating of 190 CFM (in free air). This Insert is
designed to operate with the blowers turned off or on. Turning the blower on
aids in distributing and circulating heat to the room this Insert is installed in.
Blower Operation
The remote-control system supplied with this appliance can turn the blowers on
or off and regulate the speed of the blowers in six levels.
NOTE: In the normal thermostat mode and the smart mode, there
will be a five-minute delay before the blower comes on and a 12-
1/2 minutes extended blower operation after fireplace flames turn
off.
Lifting Handles
Two lifting handles, one on each side, are provided. The lifting handles make it easy for two individuals to lift this Insert.
WARNING
: The lifting handles are designed only for lifting and moving the fireplace short distances. Such as lifting the
fireplace onto a transport cart or shifting the fireplace during installation. Do not attempt to carry this fireplace by the lifting
handles only.
Note: Team lifting is recommended.
To use the lifting handles, remove two screws that secure the upper section of the
lifting handles and pull top section outward. Slide hands into the opening of the
lifting handle, grip top U-shaped section tightly and lift.
Once this Insert is moved to its final location, you may remove and discard the lifting
handles, if necessary, to reduce the width of this Insert.
Convection Blower System
Lifting Handles