48
WIKA operating instructions hydraulic high pressure controller, model CPC8000-H
PN 0018708001B 11/2020 EN
EN
6. Operation
Figure 6.4.2.5.1-A Programs Display
The Edit tab(Figure 6.4.2.5.1-B), allows the user to edit existing programs or create steps in new ones. Pressing a command
or data point will present the available commands or data entry type in the side bar. The Insert/Delete buttons allow insertion
or deletion of commands and data entries. Selections of commands and data in each sequential line will create a sequence of
commands that will be processed when a program is selected on the Main screen. Once you exit the Edit menu, the instrument will
prompt the user to "Replace old values?". Pressing the will accept the changes, and pressing the will revert back to the old
program. A list of the available commands, data values and functions are shown below.
Figure 6.4.2.5.1-B Edit Programs
Program Commands
DELAY
Delay for time = 0.0 to 3600.0 seconds (Numerical Entry)
SETPOINT% Changes the setpoint to a percentage of Full Scale
MODE
Sets the mode of the instrument (Control, Measure, or Vent) WAIT
Waits for a manual input or stable conditions
PTYPE
Sets the pressure type (Gauge or Absolute)
RSETPT
Changes the rate setpoint (Numeric Entry)
UNITS
Sets the pressure units
RUNITS
Set the rate time units (seconds or minutes)
SENSOR
Sets the active sensor
ZERO
Set the zero calibration of the active sensor with the
reference sensor at 0, the barometer or reset back to factory.
SEQSTART
Restarts the sequence at the beginning
LOOP
Loop back to the specified step X number of times (Numeric
Entry). Number of times may be indefinite.
SETPOINT
Changes the setpoint (Numerical Entry)
