18
WIKA operating instructions hydraulic high pressure controller, model CPC8000-H
PN 0018708001B 11/2020 EN
EN
4. Transport, Packaging and Storage
4.1 Transport
Check the hydraulic high pressure controller CPC8000-H for any damage that may have been caused by transport.
Obvious damage must be reported immediately.
CAUTION!
Damage through improper transport
With improper transport, a high level of damage to property can occur.
▶
When unloading packed goods upon delivery as well as during internal transport, proceed carefully and observe
the symbols on the packaging.
▶
With internal transport, observe the instructions in chapter 4.2 “Packaging and storage”.
WARNING!
Physical injuries to personnel caused by heavy weight
Carefully follow all transport, packaging and storage instructions to prevent injuries caused by the weight of the
CPC8000-H.
If the instrument is transported from a cold into a warm environment, the formation of condensation may result in instrument
malfunction. Before putting it back into operation, wait for the instrument temperature and the room temperature to equalize.
4.2 Packaging and storage
The CPC8000-H is packaged inside a custom crate and strapped down to a pallet.
Keep the packaging, as it will provide optimum protection during transport (e.g. change in installation site, sending for repair).
Permissible conditions at the place of storage:
■
Storage temperature: 5 ... 70 °C
■
Humidity: 0 ... 95 % relative humidity (no condensation)
Avoid exposure to the following factors:
■
Direct sunlight or proximity to hot objects
■
Mechanical vibration, mechanical shock (putting it down hard)
■
Soot, vapor, dust and corrosive gases
■
Hazardous environments, flammable atmospheres
■
Direct exposure to air vent
4. Transport, Packaging and Storage
