12
Adjusting gain
The gain determines how fast the ACS should correct a list condition. It can be adjusted in three steps
and the default setting is step I. Step II provides a correction that is a little faster, while step III is the
fastest. The setting is optimized, if a list condition is corrected without the boat leaning over to the
other side and the trim tabs are not operated too often.
Press the left and right button
simultaneously for 4 seconds until an
indicator in the middle starts to blink.
Adjust the gain setting with the uppermost
and lowermost buttons. The three indicator
LED’s in the middle show the setting.
Then, press the left and right buttons again
for 4 seconds to store the setting.
Retraction
Retraction prevents fouling of the actuators. ACS automatically retracts the trim tabs when the boat has
been off the plane for a while. If terminal 7 has been connected to the ignition, ACS will not retract the
trim tabs until the engine is switched off.
Shut down
When not in use for a while, ACS shuts down, drawing minimal current from the battery. This feature
prevents battery drain and the boat may be left for months with the main breakers on.
The ACS will be activated again when there is a need to adjust the trim tabs.
