EN
18
FROTHING AND WARMING
NOTE:
Add no more than 100 ml of milk, otherwise
it can run over after frothing.
1. Place the milk frother on a stable,
level surface.
2. Open the lid and place the frother on the
axle in the bottom of the jug.
3. Pour in the required amount of milk and
replace the lid.
4. Place the jug on the base and plug the
plug into a power point.
5. Press the power switch once to start the
milk frother. The power switch goes blue.
6. When the power switch goes red the
frothing and warming are ready and the
lid can be taken off.
7. Unplug the plug from the power point
after use.
WARMING
NOTE:
Add no more than 200 ml of milk, otherwise
it can run over after warming.
1. Place the milk frother on a stable,
level surface.
2. Open the lid and place the mixer on the
axle in the bottom of the jug.
3. Pour in the required amount of milk and
replace the lid.
4. Place the jug on the base and plug the
plug into a power point.
5. Press the switch button once to start the
milk frother. The status lamp goes blue.
6. When the power switch goes red the
warming is ready and the lid can be
taken off.
7. Unplug the plug from the power point
after use.
TECHNICAL DATA
Voltage
230 V ~ 50 Hz
Output 450 W
Capacity
450 ml
DESCRIPTION
1. Base
2. Power switch
3. Lid
4. Handle
5. Jug
6. Mixer
7. Frother
FIG. 1
USE
NOTE:
• Before using for the first time, clean all
the part in accordance with the
instructions.
• Use cold milk (5–10°C).
• Allow the milk frother to stand for at
least 3 minutes after using it and before
using it again. If the milk frother is used
5 times in succession the overload
protection will trip, the status lamp will
flash blue, and the power switch will not
work. After about 5 minutes the milk
frother will reset to standby mode and
can be used again.
• The mixer prevents burning during the
warming. The frother is used to froth hot
or cold milk.
• The milk frother can be switched off at
any time by pressing the power switch
once.
Summary of Contents for 001451
Page 3: ...1 3 4 5 2 1 6 7 ...