Menuett 006587, Operating Instructions Manual

EN

28

LEVELLING

•  It is very important that the fridge is 

levelled on installation, otherwise the 
door might not close properly which can 
cause inadequate cooling or problems 
with frosting or moisture. 

•  Turn the levelling foot clockwise to raise 

the level or anticlockwise to lower it. 

     NOTE:   
It is easier to adjust the levelling foot if 
someone lifts the fridge slightly to relieve the 
levelling foot.

Put on the door.

1.  Pull out the plug and empty the fridge. 
2.  Adjust the two levelling feet to the highest 

position. 

3.  Undo the screws that hold the top plate 

with a Phillips screwdriver and lift off the 
top plate. 

     FIG.   2

4.  Undo the screws that hold the top hinge 

with a Phillips screwdriver. 

     FIG.   3

5.  Move the top hinge, doorstop and 

bushing to the other side.  
A.  Fit the top hinge. 

     FIG.   4

B.  Fit the bushing and doorstop. 

     FIG.   5

6.  Undo the screws that hold the bottom 

hinge with a Phillips screwdriver and fit the 
hinge on the other side with the screws.

     FIG.   6

7.  Move the levelling foot to the other side 

and adjust so that the fridge is level.

     FIG.   7

8.  Put the door in place, fit the top hinge, 

and replace the top plate. 

     FIG.   8

     WARNING!   
At least two persons are needed to lift the 
fridge, otherwise there is a risk of personal 
injury. 

SPACE REQUIREMENT

•  Leave at least 200 mm of free space on 

each side, 200 mm behind and 300 mm 
above the fridge, to ensure adequate 
ventilation. 

•  If the fridge is placed adjacent to a wall, 

leave enough space to open the door. 

•  Do not put the fridge near a source of 

heat, or in direct sunlight. 

ELECTRICAL CONNECTION

•  The fridge must only be connected to a 

correctly earthed power point, 220–240 
VAC, 50 Hz, with a mains fuse of 10 A. 

•  The fridge should be connected to a 

separate circuit. 

•  Do not connect the fridge to a power 

point that can be switched off. 

•  Do not use an extension cord.

     NOTE:   
Pull out the plug before installation. When 
ready, plug in the plug and adjust the settings.

ELECTRICAL DATA

•  Failure to follow all the instructions and 

safety instructions can lead to the risk of 
electric shock, fire, serious personal injury 
and/or material damage. 

•  Check that the mains voltage corresponds 

to the rated voltage on the type plate. 

     WARNING!   
The plug must be plugged into a correctly 
installed earthed power point. Never modify 
the plug in any way. Do not use an extension 
cord or plug adapter, or the equivalent.