Menuett 009029, Operating Instructions Manual

EN

18

7.  Wait for one minute after the reservoir is 

empty before removing the pot to make 
sure all the coffee has run down from the 
filter.

8.  You can keep the coffee hot on the hob for 

up to 40 minutes after the brewing. The 
hob switches off after 40 minutes. Serve 
freshly brewed coffee for the best taste. 

9.  Switch off the coffee maker and pull out 

the plug after use. 

     NOTE:   

•  The pot can only be removed for up to 

30 seconds during the brewing without 
coffee dripping from the filter. If the pot 
is not replaced within 30 seconds,  
the coffee will overflow in the funnel.

•  The volume of brewed coffee is slightly 

less than the added water volume, as 
the coffee powder absorbs some of the 
water. Parts of the coffee maker get very 
hot when in use – Risk of burn injury 
and/or scalding.

•  Newly brewed coffee is hot – Risk of 

scalding.

TIPS FOR GOOD COFFEE

•  For best results and taste it is important to 

keep the coffee maker clean. Clean the 
coffee maker regularly according to the 
instructions. Use only fresh, cold water in 
the coffee maker.

•  Store coffee in a dry and cool place. Close 

the packet properly, and store in the fridge 
for best shelf life.

•  For optimum coffee taste, use whole 

coffee beans and grind them just before 
brewing.

•  Never brew coffee more than once with 

the same coffee. It is not advisable to 
warm up coffee that has gone cold – 
coffee tastes best immediately after 
brewing.

DESCRIPTION

1.  Cover for water reservoir
2.  Water reservoir
3.  Pot
4.  Switch
5.  Cover for filter holder
6.  Filter holder
7.  Drip stopper
8.  Hotplate

     FIG.   1

HOW TO USE

BEFORE USING FOR THE FIRST TIME

Check that all the accessories are included  
and that the coffee maker is undamaged.  
Fill up with fresh water to the MAX mark, start 
the coffee maker and allow the water to run 
through without adding coffee. Pour out the 
water. Repeat several times. Wash all loose 
parts thoroughly with hot water. 

HOW TO USE 

1.  Open the lid and fill the tank with drinking 

water. Do not fill above the MAX mark on 
the level indicator. 

2.  Fold out the funnel holder, place the 

funnel in the funnel holder and then place 
the filter in the funnel. 

3.  Fill the filter with coffee powder. As a rule, 

use one level tablespoon of coffee powder 
per cup, depending on personal taste. 
Fold in the funnel holder so that it clicks 
into place. 

4.  Place the pot on the hotplate.
5.  Plug in the plug.
6.  Press the power switch so that the status 

lamp goes on. The brewing starts.