Run for about ten minutes before replacing outlet plug.
Volume Reference Table:
Shaft diameter (at face of bearing)
Grease amount (ounce)
0.8in to 1.2in
1.5g to 2.8g
(0.05 to 0.1)
1.4in to 1.8in
3.1g to 5.7g
(0.11 to 0.2)
2.0in to 2.2in
12.3g to 17g
(0.43 to 0.6)
2.4in to 3.3in
32.8g to 45g
(1.16 to 1.6)
Caution :
over-greasing is a major cause of bearing and motor failure. Make sure that dirt and
contaminants are not introduced when adding grease.
INVERTER DUTY APPLICATION
Please refer your application to
MAX MOTION
or its nearest distributor for instruction.
STORAGE
If the motor is not packaged for long-term storage and is not to be put into service immediately,
certain precautions should be taken to protect it. If at all possible, place the motor under cover in
a clean and dry location.
During storage, the winding should be protected from excessive moisture absortion by some safe
and reliable method of heating. Space heaters, if supplied, may be used for this purpose. The
temperature of the winding should be always maintained a few degrees above the temperature of
the surrounding air.
