Web proxy settings
These settings take effect if the MX device has to fall back to using HTTP to contact the Cloud Controller.
By default, web proxy is disabled. To enable web proxy, do the following:
Choose
Web proxy > Yes
.
Enter values as appropriate for
Hostname or IP
and
Port
.
If you require authentication, choose
Authentication > Use authentication
, and enter appropriate
values for
Username
and
Password
.
To apply all configuration settings to the appliance, be sure to click
Save Settings
at the bottom of the
page.
Configuring physical link settings
To configure physical link settings on the Ethernet ports, click
Local status > Ethernet configuration
.
You can enable half duplex, full duplex, and auto-negotiation, as well as set 10- or 100-Mbps data rates.
Regulatory
FCC Compliance Statement
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Party issuing Supplier’s Declaration of Conformity
Cisco Meraki
500 Terry A. Francois Blvd.
San Francisco, CA
94158
USA
compliance@meraki.com
FCC Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to correct the interference by
one of the following measures:
• Reorient or relocate the receiving antenna.
