Please note that the serial number is located on the product label, which is located on the bottom of the
MX68W. The blank region in the center of the label will be populated with regulatory marks on
commercial units.
Mounting hardware
The supplied wall screws and anchors allow you to mount the appliance on a drywall surface, either
vertically or horizontally. The distance between the holes you drill should be 165 mm.
For mounting on drywall, use a ¼ -in drill bit, then insert the plastic and screw assemblies.
For mounting on wood or a similar surface, use only the screws.
Allow the heads of the screws to stick out far enough to be inserted securely into the back of the
appliance.
T
his equipment is only suitable for mounting at heights ≤ 2 m
Warning: This equipment may not work when mains power fails.
Connecting to the WAN
All Meraki MX devices must have an IP address. This section describes how to configure your local area
network before you deploy it. A local management web service, running on the appliance, is accessed
through a browser running on a client PC. This web service is used for configuring and monitoring basic
ISP/WAN connectivity.
