X
Position jack
?
at jacking point
=
.
X
Make sure that the base of the jack is posi-
tioned vertically under the jacking point.
X
Turn ratchet ring spanner
A
until jack
?
sits completely on jacking point
=
and the
base of the jack lies evenly on the ground.
X
Turn ratchet ring spanner
A
until the tyre
is raised a maximum of 3 cm from the
ground.
Removing a wheel
!
Do not place wheel bolts in sand or dirt.
The threads of the wheel bolts and wheel
hubs could otherwise be damaged when
the bolts are tightened.
X
Unscrew the wheel bolts.
X
Remove the wheel.
Fitting a new wheel
G
WARNING
Oiled or greased wheel bolts or damaged
wheel bolts/hub threads can cause the wheel
bolts to come loose. As a result, you could
lose a wheel while driving. There is a risk of
accident.
Never oil or grease wheel bolts. In the event
of damage to the threads, contact a qualified
specialist workshop immediately. Have the
damaged wheel bolts or hub threads
replaced/renewed. Do not continue driving.
G
WARNING
If you tighten the wheel bolts or wheel nuts
when the vehicle is raised, the jack could tip
over. There is a risk of injury.
Only tighten the wheel bolts or wheel nuts
when the vehicle is on the ground.
Always pay attention to the instructions and
safety notices in "Changing a wheel"
(
Y
page 324).
Only use wheel bolts that have been designed
for the wheel and the vehicle. For safety rea-
sons, Mercedes-Benz recommends that you
only use wheel bolts which have been
approved for Mercedes-Benz vehicles and the
respective wheel.
X
Clean the wheel and wheel hub contact
surfaces.
X
Place the new wheel on the wheel hub and
push it on.
328
Changing a wheel
Wheels and tyres
Summary of Contents for 2012 A-Class
