Switching the Intelligent Light System
on/off
X
Press the
=
or
;
button on the steer-
ing wheel to select the
Settings
menu.
X
Press the
:
or
9
button to select the
Light
submenu.
X
Press
a
to confirm.
X
Press the
:
or
9
button to select the
Intell. Light System
function.
If the
Intell. Light System
function has
been switched on, the cone of light and the
L
symbol in the multifunction display
are shown in orange.
X
Press the
a
button to save the setting.
When you activate
Intell. Light System
,
you activate the following functions:
R
Motorway mode
R
Active light function
R
Cornering light function
R
Extended range foglamps
If you set the dipped-beam headlamps for
driving on the right/left, the multifunction
display shows the
Intell. Light System:
System inoperative Inactive for
left-side traffic
or
Intell. Light
System: System inoperative Inactive
for right-side traffic
display message
instead of the
Intell. Light System:
function in the
Light
submenu.
Further information on the Intelligent Light
System (
Setting the dipped-beam headlamps for
driving on the left/right
X
Press the
=
or
;
button on the steer-
ing wheel to select the
Settings
menu.
X
Press the
:
or
9
button to select the
Light
submenu.
X
Press
a
to confirm.
X
Press the
:
or
9
button to select the
Dipped beams Setting for:
function.
You will see the selected setting:
Right-
side traffic
or
Left-side traffic
.
X
Press the
a
button to save the setting.
If you change the setting, conversion does
not take place until the next time the vehi-
cle is stationary.
This function is only available on vehicles with
the Intelligent Light System.
You can use this function to switch between
symmetrical and asymmetrical dipped beam
(
If you set the dipped-beam headlamps for
driving on the right/left, then motorway
mode and the extended range foglamps are
unavailable.
A qualified specialist workshop can set the
dipped-beam headlamps for driving on the
right or left.
Switching Adaptive Highbeam Assist on/
off
X
Press the
=
or
;
button on the steer-
ing wheel to select the
Settings
menu.
X
Press the
:
or
9
button to select the
Light
submenu.
X
Press
a
to confirm.
X
Press the
:
or
9
button to select the
Adapt. main beam
function.
If the
Adapt. main beam
function has
been switched on, the cone of light and the
_
symbol in the multifunction display
are shown in orange.
X
Press the
a
button to save the setting.
For further information about Adaptive High-
beam Assist, see (
Activating/deactivating the surround
lighting and exterior lighting delayed
switch-off
X
Press the
=
or
;
button on the steer-
ing wheel to select the
Settings
menu.
X
Press the
:
or
9
button to select the
Light
submenu.
232
Displays and operation (12-button multifunction steering wheel)
On-board computer and displays
Summary of Contents for 2013 C-Class Coupe
