R
at a qualified specialised workshop
R
via the HomeLink
®
Hotline
(0) 08000 466 354 65 or alternatively
+49 (0) 6838 907-277
R
on the Internet at
http://www.homelink.com
Important safety notes
G
WARNING
When you operate or program the garage door
with the integrated garage door opener, per-
sons in the range of movement of the garage
door can become trapped or struck by the
garage door. There is a risk of injury.
When using the integrated garage door
opener, always make sure that nobody is
within the range of movement of the garage
door.
G
WARNING
Combustion engines emit poisonous exhaust
gases such as carbon monoxide. Inhaling
these exhaust gases leads to poisoning. There
is a risk of fatal injury. Therefore never leave
the engine running in enclosed spaces with-
out sufficient ventilation.
Programming
Programming buttons
Pay attention to the "Important safety notes"
(
Y
page 392).
Integrated garage door opener in the rear-view mir-
ror
Garage door remote control
A
is not inclu-
ded with the integrated garage door opener.
X
Turn the key to position 2 in the ignition
lock (
Y
page 191).
X
Select one of buttons
;
to
?
to use to
control the garage door drive.
X
To start programming mode: press and
hold one of buttons
;
to
?
of the inte-
grated garage door opener.
The garage door opener is now in program-
ming mode. After a short time, indicator
lamp
:
begins to light up yellow.
Indicator lamp
:
lights up yellow immedi-
ately the first time button
;
,
=
or
?
is
programmed. If the selected button has
already been programmed, indicator
lamp
:
lights up yellow after ten seconds
have elapsed.
X
Release button
;
,
=
or
?
. Indicator
lamp
:
flashes yellow.
X
To program the remote control: point
garage door remote control
A
towards
buttons
;
to
?
on the rear-view mirror at
a distance of 5 to 20 cm.
X
Press and hold button
B
on remote control
A
until indicator lamp
:
lights up green.
When indicator lamp
:
lights up green:
programming is finished.
When indicator lamp
:
flashes green: pro-
gramming was successful. The next step is
to synchronise the rolling code.
X
Release button
B
of remote control
A
of
the garage door drive.
If indicator lamp
:
lights up red: repeat
the programming process for the corre-
sponding button on the rear-view mirror.
When doing so, vary the distance between
remote control
A
and the rear-view mirror.
The required distance between remote
control
A
and the integrated garage door
opener depends on the garage door drive
system. Several attempts may be required.
You should test every position for at least
25 seconds before trying another position.
392
Features
St
owing
and
fea
tu
res
Summary of Contents for 2013 S-CLASS
