Programming
Programing buttons
Pay attention to the "Important safety notes"
(
Y
page 270).
Garage door remote control
A
is not inclu-
ded with the integrated garage door opener.
X
Turn the SmartKey to position 2 in the igni-
tion lock (
Y
page 139).
X
Select one of buttons
;
to
?
to use to
control the garage door drive.
X
To start programing mode: press and
hold one of buttons
;
to
?
on the inte-
grated garage door opener.
The garage door opener is now in program-
ing mode. After a short time, indicator
lamp
:
lights up yellow.
Indicator lamp
:
lights up yellow as soon
as button
;
,
=
or
?
is programed for the
first time. If the selected button has already
been programed, indicator lamp
:
will
only light up yellow after ten seconds have
elapsed.
X
Release button
;
,
=
or
?
. Indicator
lamp
:
flashes yellow.
X
To program the remote control: point
garage door remote control
A
towards
buttons
;
to
?
on the rear-view mirror at
a distance of 2 to 8 inches (5 to 20 cm).
X
Press and hold button
B
on remote control
A
until indicator lamp
:
lights up green.
When indicator lamp
:
lights up green:
programing is finished.
When indicator lamp
:
flashes green: pro-
graming was successful. The next step is to
synchronize the rolling code.
X
Release button
B
on remote control
A
for
the garage door drive system.
If indicator lamp
:
lights up red: repeat the
programing procedure for the correspond-
ing button on the rear-view mirror. When
doing so, vary the distance between remote
control
A
and the rear-view mirror.
The required distance between remote
control
A
and the integrated garage door
opener depends on the garage door drive
system. Several attempts might be neces-
sary. You should test every position for at
least 25 seconds before trying another
position.
Synchronizing the rolling code
Pay attention to the "Important safety notes"
(
Y
page 270).
If the garage door system uses a rolling code,
you will also have to synchronize the garage
door system with the integrated garage door
opener in the rear-view mirror. To do this you
will need to use the programing button on the
door drive control panel. The programing but-
ton may be positioned at different locations
depending on the manufacturer. It is usually
located on the door drive unit on the garage
ceiling.
Familiarize yourself with the garage door
drive operating instructions, e.g. under "Pro-
graming of additional remote controls",
before carrying out the following steps.
Your vehicle must be within reach of the
garage door or gate opener drive. Make sure
that neither your vehicle nor any persons/
objects are present within the sweep of the
door or gate.
X
Turn the SmartKey to position 2 in the igni-
tion lock (
Y
page 139).
X
Get out of the vehicle.
X
Press the programing button on the door
drive unit.
Features
271
Stowage
and
features
Z
Summary of Contents for 2015 SLK
