Mercedes-Benz G 55 AMG Operator'S Manual Download

Page: 208 / 284

If indicator lamp

goes out after

approximately 20 seconds and has not
flashed rapidly:

Release transmitter buttons

;

on the integrated remote control and
transmitter button

on the garage door

remote control.

Repeat the procedure for the other
transmitter buttons. When doing so, vary
the distance between the garage door's
remote control and the transmitter buttons
in the rear-view mirror.

If the garage door system works with a

rolling code, you must synchronize the
remote control integrated into the rear-
view mirror with the garage door system
receiver after programming.
You will find further information in the
garage door opening system's operating
instructions, e.g. the sections on
"Synchronizing the transmitter" or
"Registering a new transmitter". You can
also call the hotline mentioned above.

Notes on programming the remote

control
Canadian radio frequency laws require a
"break" (or interruption) of the transmission
signals a few seconds after broadcasting.
Therefore, these signals may not last long
enough for the integrated remote control to
recognize the signal during programming.
Comparable with Canadian law, some U.S.
garage door openers also have a built-in
"interruption".
If you live in Canada or have difficulties
programming the garage door opener
(regardless of where you live) when using the
programming steps (see above), proceed as
follows:

Press transmitter button (

;

) and

hold it down during the following steps until

the setup has been completed
successfully.

At the same time, press transmitter button

of the garage door remote control for

two seconds, then release it for two
seconds, then press it again for two
seconds.

Repeat this sequence on transmitter
button

of the garage door remote

control until the frequency signal has been
saved.

If the setup procedure is successful,
indicator lamp

flashes once slowly and

goes out after a few seconds.

Continue with the other programming
steps (see above).

Problems when programming
If you have problems when programming the
integrated remote control, please note the
following:

check the transmitter frequency of garage
door remote control

(which can usually

be found on the rear of the remote control).
The integrated remote control is
compatible with devices that operate at
frequencies between 280 and 390 MHz.

replace the batteries in garage door remote
control

. This increases the likelihood of

garage door remote control

sending a

strong and precise signal to the integrated
remote control on the rear-view mirror.

when programming, hold garage door
remote control

at varying distances and

angles from the transmitter button which
you are programming. Try different angles
at a distance between 2 and 12 inches (5
to 30 cm) or the same angle at varying
distances.

if there is another garage door remote
control for the same device, perform the
programming steps again using that garage
door opener. Before performing these
steps, make sure that there are new

206

Features

Stowing and features