2, Installation ot J-bhapod otic
ot tho whoolss insen tho whoois into tho (tont axlo and tiX
Insert tho
J•shaped
stick (part 12) into the car-front
thorn, press tho cont0f button of tho Wh0018 to pull out
assiqnod qonrbox, and thon fix it with gearbox
whools 'tom tho axlo $0 as to rotoovo tho whools.
scrow (part 21
J. lostallatvon of steering
O
•ar
body
Pluq.i
hole
Plug the wire plug ot the steering wheol into tho
wire plug from the car body hole correspondingly,
and then put the connected plugs jnto tho car
body holo.
4. Installation of power supply and seat
Battery black-plug (-)
Battery
Stack cable—e
od cabl
Ctrcu't board
placog box
o
When the power supply is installed. insert the red
cable terminal into the battery positive pole.
Note: the red cable is connected to the battery
red-plug (+). and the black cable is connected to
the battery black-plug
namely connect same
color battery cables and main distribution cables
together. and the wrong connection of different
color cables will cause short circuit.
3
13
Install the steering wheel (part 3) on the J-shaped stick.
and thon tighten it with tho steering wheel screw
(part13) and screw cap (part 15).
Handle
7
Fixing
block
After the power supply is installation. put the seat and seat
fixing block (part 7) into the buckle position holes according
to the direction indicated by the arrow. tighten it with the
fixing block screw (pad 14). and pull the handle to push the
seat back to the original position.
