70mm
screw
100mm
screw
*Cut down trims to fit
Measure the height of the doors and cut two trims to
match. Fix the strips onto the gable using 6 x 30mm
screws.
Measure across from the edges of the strip and cut the
third strip to match.
Fix the T Hinges onto the doors and door gable as
shown. Ensure that the screws go through the
cladding and into the framing behind.
51x30mm screws
Step 10
30mm
screw
Pre drill
hole
Step 11
Place a Truss central to where two
panels join. Align the top of the
truss with the top of the sides as
shown in the diagram.
HINT - Use a piece from the fixing
kit as a guide.
Pencil mark the truss position and
remove truss.
Place the truss blocks up to the
pencil mark and fix using 2x70mm
screws per block.
Place the truss back into position on
top of the support block and secure
using 100mm screw each side from
the top down through the truss and
into the block.
4x70mm Screws
2x100mm Screws
Pre drill
hole
Pre drill
hole
15
12
12
21
20
20
20
