*Before fixing the door gable, check
the top and bottom of the door and
remove any transit screws . Make sure
door opens and closes freely. Adjust
hinge position if necessary.
Step 3
Fix door gable and window side
using same method shown in
step 2.
Position the panels so there is
equal spacing between the floor
and cladding on all four sides.
17 x 50mm screws
4
1
50mm
screw
Step 4
Place roof purlins inbetween
each gable upright as shown in
illustration below, Use 1x70mm
screw per end. Screw through
the outside of building, into
into framing.
*
Ensure all fitted screws do
not protrude from framing
and any splinters on surface
are removed. We
recommend finshing
framing surfaces with sand
paper to remove any
splinters.
Purlins
Ensure both purlin
edges are flush
with rafters
Rafters
6x70mm screws
9
9
70mm
screw
30mm
screw
7
5
Step 5
Screw the Eaves on to the
bottom of the large roof
sheet, Using 6x 30mm screws.
Fix roof sheets into postition
using 30mm screws, straight
into the rafter. Pre drill holes
before hand.
Start at the bottom align the
osb sheet with the purlins.
34x30mm Screws
6
Step 6
120 x felt tacks
16
Cut felt into 3 sheets and lay
onto roof as shown in
diagram ensuring there is a
50mm overhang around the
sides.
fix using felt tacks at 100mm
intervals
Felt
tacks
