P 7
Please retain product label and instructions for future reference
Felt
tacks
Step 18
Parts needed - No. 31 QTY 1
Cut three strips from the roll of felt
(No.
31)
, 2x3020mm and 1x1420mm in length.
Place the sheets of felt onto the roof
panels working from the back corner and
align as shown in the diagram ensuring
strip 3 over hangs the front by 50mm.
with equal spacing at each corner.
*Ensure strip 1 is the first piece placed
down then lay sheet 2 and then 3. Make
sure each sheet overlaps the next by at
least 100mm creating a run off.
Use a fascia as a guide to mark out the
angled cuts including 50mm overhang.
Cut the sides as shown in diagram at the
dotted lines, use fascia width as a cutting
guide. Cut the triangle with 50mm
overhang again using fascia as a guide.
100x Felt Tacks
HANDLE
WITH CARE
1
2
3
4
1
2
50
mm
50
mm
50
mm
3020mm
1000mm
1420mm
50
mm
Fr
ont
Corner
Corner
Triangle
3
**If Shed add on Pack has been purchased,
please move onto the Add on Pack Instructions**
Step 17
Parts needed - No. 18 QTY 4
Fit the Cover Trims
(No.18)
to the front
of the building onto the joins of the
panels, secure using 3x30mm screws
per cover trim.
12x30mm Screws
30mm
screw
Pre drill
hole
18
18
18
18
Pre drill
hole
40mm
screw
Fix the rain guards
(No.28)
above
each window, securing in place using
2x50mm screws per guard, ensuring
to screw through the framing.
Fix the rain guard
(No.29)
above the
door, secure using 3x50mm screws,
ensuring to screw through to the
framing
7x50mm Screws
Step 16
Parts Needed -
No.28 QTY 2
- No.29 QTY 1
29
28
28
Summary of Contents for 03DTSHCR0707FGD2TW-V1
Page 9: ...2 1 3 4...
Page 10: ...1 2...