P 6
Please retain product label and instructions for future reference
Please retain product label and instructions for future reference
Step 11
Cut four strips from the roll of felt,
1x2120mm
(5)
, 1x3820mm
(4),
1x4525mm
(3),
1x3535mm
(2)
and 1x1735mm
(1)
in length.
Place felt on top of roof sheet and align as shown
in the diagram, ensuring strip
5
overhangs the front
by 50mm and strip
1
overhangs the back by 200mm,
with equal spacing at each corner.
*Ensure strip 1 is the first piece placed down,
then lay sheet 2, then sheet 3, then sheet 4
and finally sheet 5. Make sure each sheet overlaps the
next by at least 100mm, creating a run off.
Use a Fascia as a guide to mark out the angled cuts,
including 50mm overhang.
Cut the sides as shown in the diagram
at the dotted lines, using Fascia width
as a cutting guide. Cut the triangle with
50mm overhang, again using a Fascia
as a guide.
150x Felt Tacks
Felt
tacks
2120mm
1000mm
1000mm
1000mm
1000mm
3820mm
4525mm
3535mm
1735mm
2
1
3
4
5
Step 12
Fix the Cover Trims
(No. 9x2, No,10x1)
plus the remaining Cover Trims from
the 8x8 Corner Summerhouse into
place using 3x40mm screws, per Trim.
9x40mm Screws
40mm
screw
10
9
9
Pre drill
hole
Step 13
Fix the Fascia Trims
(No. 11x2),
plus the
remaining Fascia Trims from the 8x8
Corner Summerhouse into place, using
3x40mm screws per Trim.
21x40mm Screws
40mm
screw
11
11
Pre drill
hole
