P 5
Please retain product label and instructions for future reference
24
23
23
23
Pre drill
hole
70mm
screw
IMPORTANT:
Pre-drill before fixing screws.
Step 3
Parts Needed - No. 23 QTY 2
No. 24 QTY 2
Place the starter boards (
No. 23
) on to assembled base frame along the
longest sides and place the first two log boards
(No. 24)
in the notch as
shown.
Ensure the boards sit square on the base using the same method used
in Step 1. Measure corner to corner, making sure the measurements are
equal.
Once the boards are square, lift up the log board
(No.24)
and fix the
starter boards in place.
Fix each of the starter boards to the frame by screwing through the
notch into the frame as shown in the illustration.
4x70mm Screws
24
24
25
26
24
29
24
Step 4
Parts needed - No. 24 QTY 10
No. 25 QTY 6
No. 26 QTY 6
No. 29 QTY 6
Following the method shown in the
illustration, lay the first 6 boards
(
No’s. 24, 25, 26 & 29)
Start by placing the front and back
boards, interlocking them with the
side boards. Then place the next side
boards, interlocking with the front
and back boards. Continue this
method until you have placed
6
boards off of the starter boards on
each side,
as shown in the illustra-
tion.
This will create your first level.
*Ensure that the boards are level
and flush with each other as you lay
each one.
Please Note:
The short boards at the
front of the building (either side of the
door and window opening’s) can be
placed either side depending on your
needs.
